I love it when a good plan comes together.

I love it when a good plan comes together.
Fellow Colorado #Ingress agent Bruce Kraemer put out a call for help late New Year's eve-eve. Could anyone 3D print up some portal keys as trophies for the upcoming awards banquet? I gladly offered up my little Printrbot Jr. but it only has a 100 x 100 mm table.
Offer accepted, the next challenge was dealing with converting a gravity defying virtual object to meatspace. The sole model on Thingiverse was pretty dreadful - non-manifold and weird internal artifacts, both common with Sketchup designs (don't use Sketchup for 3D printing kids!), but it was a start. After a pass through netfabb to clean up the manifold issues and then some quality time in Tinkercad to tidy things up, I had a usable model (http://www.thingiverse.com/thing:219561). Next challenge was how the heck to crank out 5 of these with enough time left for Bruce to do the finishing.
With tons of overhangs, this model was not FDM printer friendly. Still, I took a shot at an all-in-one print, instructing Slic3r to use support. Seven hours later on New Year's morning, I had my 1st failed print. It was clear there was no way to remove all that support material without wrecking the actual model. There was also the problem of a 7 hour print. There was simply no way to crank 'em all out in time. Back to Tinkercad I went...
I deconstructed the model into support-free printable parts. An added benefit of this was I could produce an even bigger finished key with some strategic part placement on the print surface. I also punted my standard Slic3r configs which focus on strength and finish for settings that absolutely maximized print speed. I pushed the Printrbot Jr's print speeds to the absolute max. Yes, print quality would definitely suffer, but time was of the essence. Print time down to 3.5 hours, I went into full production mode. It was still going to be close.
The Jr. cranked away, hour after hour. Meanwhile I worked with the awesome OctoPrint team troubleshooting a camera issue on the Raspberry Pi that drives my Printrbot. Things were going good. With parts for four keys complete by late Thursday, I kicked off one last print before bed. I'd get up early to epoxy the finished parts together and make the world's very first Ingress physical key exchange with Bruce Friday morning at 8am.
At 0-dark thirty Friday morning, I roll out of bed and head to the shop. The Printerbot is idling finished but uh oh, problem. The X-axis belt tensioner had vibrated loose and the bed shifted. Two of the portal key parts were salvageable but one was not. Time to rush one last print of the botched piece! Meanwhile, I mixed up epoxy and fabbed some cardbord jigs to hold the various pieces in place while the glue set. One key done... then two... then four... Go go Printrbot! Finally it finished and the last key was resting safely in the glue jig while I got ready to make the handoff.
Honestly, these were pretty far from my best work. There wasn't enough room on the Printrbot Jr. surface to run brims so there was some warping. Surface finish... Ugh. The keys were also so hollow with only 10% infill that they were stupid fragile. Still, they were done and with just enough time for Bruce to work his magic. And as one can see from the pic, that he did!
Like I said, I love it when a good plan comes together. #Makers rule!
Andre Tomas, prémios para um cross faction.
ReplyDelete